Flow Ranges and Accuracies available as of July 2003:

Gas Flow: Calibrations typically performed with Air or Nitrogen, but other calibration gasses are available.

Typical Calibrations:

Range	Tolerance
2 sccm to 5 LPM	0.2% RDG
> 5 LPM to 30 LPM	0.3% RDG
> 30 LPM to 100 LPM	0.5% RDG
1.0 - 100 scfm	0.5% RDG

Special test or calibration accuracies also available: (Higher flow rates, or accuracies better than 0.2% RDG are available through one of our strategic suppliers.)

Liquid Flow: Calibrations typically performed with water.

Typical Calibrations:

Range	Tolerance
200 ccm	0.25% RDG
1000 ccm	0.25% RDG
300 gpm	0.5% RDG
1200 gpm	0.5% RDG

(Flow rates above 1500 gpm, or accuracies better than 0.25% rdg are available through one of our strategic suppliers.)

Clamp-on Ultrasonic Flowmeters: Calibrations are performed with water, on varied pipe sizes, but other calibration fluids and pipe sizes are available. Accuracies of 5% RDG are typical, but better accuracies may be available.

Typical Calibrations:

Diameter	SCH	Material
1/2	40	Carbon
1/2	40	Stainless
3/4	40	Stainless
3/4	80	Carbon
1	40	Carbon
1	40	Stainless
1	80	Carbon
1 1/2	40	Stainless
1 1/2	80	Carbon
1 1/2	80	Stainless
2	40	Carbon
2	40	Stainless
2	80	Stainless
2 1/2	40	Carbon
3	40	Stainless
3	80	Carbon
3	80	Stainless
4	40	Carbon
4	40	Stainless
5	40	Carbon
6	40	Stainless
8	40	Stainless
Special
2	10	Stainless
2	160	Stainless
4	10	Stainless
4	160	Stainless
6	160	Stainless

Thermal Anemometers, Pitot Tubes & Vane Anemometers:

Calibrations for anemometers are available through one of our strategic suppliers.